Setup

1. Fill your tub or Nuvio Pod with minimal water in the coolest area possible for faster cooling.

2. Place the chiller next to the tub on a stable surface, leaving a 20-inch gap around it for airflow; avoid covering it.

3. Remove port stoppers, securely twist hoses onto chiller ports to prevent leaks.

4. Attach the small hose connector to the water pump, then connect it to one of the hoses.

5. Submerge the pump fully BEFORE plugging it into a power source. You can secure it to the tub’s side if flat.

6. Place the other hose into the tub.

7. Plug in the chiller, switch on the power and remove the screen protector.

8. Set your temperature using the remote or on-screen display. Press ‘SET’ and use UP/DOWN arrows; hold to adjust faster.

9. ALWAYS unplug or turn off the water pump BEFORE entering the tub.

Switching °F/°C: Hold both 'MODE' & 'SET', press 'MODE', use the up arrow to change, then press 'MODE' again to confirm.

Maintenance

1. To ensure clean ice bath water, we recommend draining & refilling the ice bath water once per week.

2. You can leave the chiller running 24/7, but we recommend turning it off for 1-2 hours once per week to optimize system efficiency.

Setup

1. Unfold the pod and fix the two halves of the supporting poles together.
2. Slide the supporting poles into the six slots on the pod.
3. Twist to close the faucet, then make sure you add the black washer before twisting the faucet on.
4. Ensure the faucet is tightly secured.
5. Secure the lid inside the pod.
6. Fill the pod to approximately three-quarters full.
7. Place your absorbent mat down to soak up any dripping water.
8. Open the air valve on the rim and inflate by mouth.
9. Secure the air valve shut.
10. When the pod is approximately three-quarters full, you're ready to take the plunge.

Maintenance

To ensure clean ice bath water, we recommend draining & refilling the ice bath water once per week.